I did have one of mine break off, but that was after it was dropped inside it's carry case.

Thanks for your suggestion, Zack. This is certainly a judgement call, because the tricky part is deciding how much sanding is too much, and the orange plastic carpenter's level surface isn't perfectly

Well done Peter.

I would like to make a suggestion for something to add to your "Supercharging the XHDATA D-808" instructions. If one sands down the top of the radio where the glue will go and also the bottom of the

891 Lesotho Ultimate Radio Maseru/Lancer's Gap was off air. Received in Botswana Airspy HF+ Discovery, SDR Console V3, random wire with binocular balun. https://youtu.be/rUddMRoRYC4 Peter Botswana

Here is my design: https://easyeda.com/3ym3ym/HF-antenna-splitter_copy It is under CC license, feel free to order PCBs from JLCPCB and build it. I think it is a good beginners project to learn SMD

------------------------- **MWDxerDB - Report** Report Date: 10/08/2021 Report Time: 11:24:06 ------------------------- Details: 07/10/2021 -21:30 / Home, Launceston Notes: Radio: Digitech AR-1733 /

Anyone building their own, especially antennas, would benefit greatly from getting a NanoVNA and learning how to use it, especially the Smith chart feature. There is a learning curve to operate it,

The two transformer ones work better. Transformer 1 is 10 turn autotransformer tapped at turn 7. This transforms 50 Ohms to 25 Ohms. (Or 75 to 37.5). The second transformer is 14 turns center

Hi Jorge, I built my own 2-way splitter called "BB-2" in this article: http://www.dxing.info/equipment/rolling_your_own_bryant.dx A couple of months later I bought a commercial 5-way splitter (ELAD

Here's the audio of Iran in Russian on 1449kHz on Mon Oct 4th from 1415UTC. Signal held out on and off, fairly well for 9

Your dedicated:)

Correction.. 1415-1420 UTC. sorry. Mitten covered fingers to blame. Paul

Pretty decent signal at times from IRIB Iran in Russian on 1449Khz at 1615-1620UTC! First heard here because KLAM is usually very strong! Paul standing outside in 15 degree weather to type this!

Hi Robert: Can you share more information and schematics?, sounds very good this approach and new design. Congrats good work! Best Regards JJ

Hi, I am considering to assembly an antenna switcher and splitter. Did you build yours or buy it from a dealer? I would like to share some beverages with a receiver or two, and also split a signal to

Sunday, October 3, 2021 Long Terms DXing Project - 3/10/2021 10am Digitech AR-1733 LTDXPFreq(MHz)Callsign30.5313GG10.5492CR40.6213RN20.6933AW40.7743LO20.8283GI20.8553CR00.8915AN11341HPON

Nor is that the only form-factor you can use. I built this one inside large plastic food jars. This is an active, regenerative FSL antenna built from 7 inch ferrite bars housed in large plastic food

Thanks... !! And I did subscribe.

Here's a few logs and clips from Just East Of The Ass end Of Gods Creation Nowhere aka McGrath, Alaska using a CC Skywave and Debock 5" FSL Antenna "Magic Talk", 1107kHz Tauranga, NZ at 1525UTC on