Hi Gary, and All. Recently an Australian DXer constructed a 135 mm diameter MW FSL using forty one Jaycar LF1010 (9 x 100 mm) ferrite rods. These rods are more affordable than anything else available

Thanks Gary. Excellent information. For domestic MW fans like myself, the Traveler III is looking good. -- Bob Richardson

https://www.ebay.com.au/itm/293583454547 Please email me directly: tanger32au@... -- Paul - Moderator UltralightDX

Thanks Gary. I happened across your excellent discussion of ultralights a few weeks back. Reading again just now, I might have to rethink the Tecsun only agenda. Or have some fun finding an original

<micron327@...> wrote: Lol! No "great errors" in hobby radio unless you are operating a transmitter. I did exercise the buttons on my '606 and they seem better (20 or so pushes

_,_._,_

I had a pair of binoculars that went the same way. I rubbed the sticky plastic with Armoural, a car interior treatment, and that did the trick. Steve

Thanks for the input. I like the antenna jack on the PL-310. But a simple induction loop would do the same. Non recessed tuning knob sounds good too. -- Bob Richardson

Thanks Gary, that's good to know for the future (not that I am planning to do any travelling for a while, due to COVID). j

It seems I have made a great error. It was not my PL-600 but my venerable RS DX-440 which has the rubbery push buttons.that developed the gummy decomposition. I don't know if there is a membrane under

On Sun, May 17, 2020 at 03:09 PM, jcfontario wrote: I have a CC Skywave portable radio, but I am not familiar with what a "supercharged" Skywave receiver has that I don't have. What do I need to add

Hi Gary, I have a CC Skywave portable radio, but I am not familiar with what a "supercharged" Skywave receiver has that I don't have. What do I need to add to my travel portable? Thanks John Fisher

Thus spake our resident Ultralight and FSL experimenter/developer extraordinaire. I can happily attest to Gary’s Ultralight and FSL prowess. 73, Craig Barnes Wheat Ridge, CO

Hello All, When both the original PL-310 and PL-380 were introduced by Tecsun in 2009-2010 they were fully reviewed (at http://www.mediafire.com/file/w4yuzhj2kyz/Tecsun_PL-380_Review.pdf/file for

<micron327@...> wrote: I wasn't clear in my description. At all. It isn't that my fingers stick to the keys (no rubber on the exterior, thankfully, metalized plastic) it's that the

I do love the preset tuning on the 310et! Press a button to get into VM mode and tune through them with the tuning knob. So much quicker and more intuitive than the banks (Pages) of seven presets each

My PL-600 developed a bad case of gummybearitis and the cure is hi proof isopropyl alcohol as given above. I'm fortunate to own a few gallons of 99.9% so cutting it down with the appropriate amount of

I love the "Tecsun way" of tuning - I love the ETM feature on the smaller models, which basically works like "Page 0" on the bigger ones. Love that you can switch between dedicated VF/VM modes so you

As far as I know soft-mute can be de-activated on both receivers. I find the recessed tuning-knob to be advantage rather. If you travel a lot and take your pl-310 in an out of your suitcase

Here's what I recall, but please, double check it... This is top of my head: PL-310 Goods: antenna jack; real, external tuning knob (you can use two fingers) Not so good: noticeable soft-mute, in