Paul, I think you are correct about skin effect amd current resistance,especially at RF frequencies below a couple MHz. Somewhere, I'veseen tables published by the Litz manufatureres giving losses

Dear Jerry this struck me also right now I have no good explanation for this more wires with same skin effect do not seem to grab me more technically somehow the Poynting Vector power flow into the

One other major and important consideration: there is a remarkable improvement in S unitage and audible gain if a secondary pick-up coil, when used for direct antenna coupling, is also made of 660/46

Probably due to the skin conductive effect

Wow, the difference Raphael found using two types of Litz wire wound on the same Stormwise Ferrite bar is stunning, even accounting for the vagaries of the Palstar R30A S-Meter (I own one). Can

Dinodirect made very interesting proposal : The anniversary celebration for DinoDirect has started! Let's come and revel together! All products on DinoDirect are involved in this campaign. It will

What? I guess I didn't explain very well. What I meant by "Crystal Set" is to add a diode and a pair of sensitive headphones to a FSA and see what it can pick up compared with a single conventional

Should help out quite a bit in helping hear signals in the noise or separate stations in a congested market (Los Angeles). I used to do similar using tuneable loopstick antenna coils and tuning

Thanks Paul, I'm sure you will be very satisfied with the 660/46 Litz wire from Ming. He is a very honest seller, and his material is top-rate. Thanks for sharing the details of your

Op 20-07-11 23:18, jerry_popiel schreef: I have disconnected the ferrite inside, and added cable + plug to the outside of my pl380. The result of listening to SW is different when (outside) ferrite

Hi folks, I've been following this Ferrite Sleeve Antenna saga with great interest. One test I would like to see is just how effective a FSA is when connected as a crystal set (but with no external

thanks Gary just changed my order with Ming from 330/46 to 660/46 100' best and thanks again for this critical information I am the fellow with the pictures of the yellow pails glued together with

Hello Jerry and All, Steve Ratzlaff discovered that 660/46 Litz wire was the best performer for FSL's, and I agree with him completely. All of my FSL's have been made with 660/46 Litz wire from the

Dear Raphael thank you for this most important piece of information best wishes Paul VE3PVB

Hi Jerry! I have used both 100/44 and 660/46 Litz wire to wrap a 38 turnprimary winding on a 19” 125 mu ferrite bar, terminating in a 365 pfdvariable capacitor for tuning the MW band. In this

I am about to order some Litz wire from the USA. Re Steve's recent Litz wire comments on his FSL Loop and Gary' use of it on his FSL Loops, does the much more expensive 660 / 46 Litz wire provide much

Jerry, the MW trap would work and the coupling ferrite, placed close to the telescopic aerial would work - probably better without the earth connection as for MW use. A shortwave tuner would be

Thanks Michael, you must be 100% correct because I have noticed with Both the Grundig G3 and Tecsun PL 380 there is No improvement to Broadcast Band / MW - even with wrapping the Longwire Antenna

Thanks Michael, that's a bit dissappointing to hear that Shortwave Listening may NOT work with the 2 Loopstick / 2 Capacitor Inductive Trap you designed to work off my Longwire Antenna to prevent

The internal loopstick with or without external ferrite antenna only receives LW and MW signals. Shortwave and FM use the telescopic aerial - so are not affected by the modification. Loosely wrap